Missing teeth should almost always be replaced so you can chew and talk normally. Dental replacements are also a good choice to improve aesthetics and to encourage a symmetrical facial appearance. Bridges are chosen in most situations to replace a missing tooth. They are relatively inexpensive when compared to other replacement options, and they do not require an invasive procedure. However, bridges do require some pretty stringent cleaning practices to keep the gums and the anchor teeth in good health. Cleaning should be completed with the assistance of super floss. Keep reading to learn what super floss is and how it can be used to clean around a bridge.
What Is Super Floss?
Super floss is a segmented piece of dental floss that has three separate parts. The very end of the floss is made up of a rigid piece of plastic or a thicker piece of floss. The middle segment is a wide and spongy piece of floss, and the end is fitted with a traditional piece of wax-coated thread. The spongy section of the floss may be made from a loosely woven piece of nylon, or it may be made from thicker cotton threads. Both types of the floss are covered in a wax coating.
Super floss is cut into individual pieces and can be purchased in boxes or packages of 50 of the flossers or more. While it is wise to use the flossers every day, you can alternate with traditional floss or with a water flosser. If you use a water flosser, use it with the traditional or classic jet tip or the orthodontic tips. Just make sure to direct and pinpoint the water spray towards the bottom of the bridge where the device meets the gums.
How Do You Use The Super Floss?
Before you begin, you should understand that the super floss should be used to clear away plaque and food on the sides of the middle pontic tooth. You can use regular floss around the sides of the anchor teeth.
Start by threading the solid and hard part of the flosser along the right side of the artificial tooth. The pontic will attach to the anchor teeth towards the top of the tooth. You want to slide the floss underneath this just to the side of where the tooth sits next to the gum tissues. Pull the hard part of the floss towards the inside of your mouth until the wide and spongy section sits between the pontic and anchor tooth. Move the floss back and forth to loosen plaque. Pull the super floss all the way through the opening when you are done and discard it.
When you finish cleaning the right side of the bridge, repeat the cleaning process on the left side. Complete the cleaning by rinsing your mouth out with water or mouthwash so the plaque frees completely and you can spit it out of your mouth. For more information on dental bridges, check out a site like http://www.SeattleRainbowSmiles.com.